Mazda 626

1991-1998 of release

Repair and operation of the car



Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and half shafts
- 9. Brake system
   9.1. Introduction
   9.2. Technical characteristics
   9.3. System of anti-blocking of brakes (ABS)
   9.4. Brake overlays of disk brakes
   9.5. Brake support
   9.6. Brake disk
   9.7. Brake shoes of drum brakes
   9.8. Wheel cylinder
   9.9. Main brake cylinder
   9.10. Brake tubes and hoses
   9.11. Pumping of the brake system
   9.12. Vacuum amplifier
   9.13. Height and free wheeling of a pedal of a brake
   9.14. Emergency brake
   9.15. Ropes of the emergency brake
   9.16. Switch of an alarm bulb of low level of brake fluid
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electrical circuitries
+ 14. Useful tips

9.11. Pumping of the brake system

GENERAL INFORMATION

If the brake tube was disconnected from the main brake cylinder or air got to it, it is necessary to pump over all brake system.

If the brake hose was disconnected only from a support of one brake, it is necessary to pump over only this support or the wheel cylinder.

If the brake tube or a hose was disconnected between the main cylinder and a brake, it is necessary to pump over only this part of the brake system.

Check

PERFORMANCE ORDER
1. Squeeze out a brake pedal several times to remove depression from the vacuum amplifier.
2. Fill a tank with brake fluid.
3. Pumping of all brake system needs to be begun with the right back wheel. Connect a hose to the valve of pumping and lower the second end of a hose in brake fluid.
4. Squeeze out a brake pedal several times and leave squeezed out.
5. Open the valve of pumping and let out the air and brake fluid.
6. Close the valve and slowly release a brake pedal.
7. Repeat the operations described in points 5 and 6 until contains in the following brake fluid vials of air. Then pump over a brake of the right forward wheel, the right back wheel and the left forward wheel. You watch liquid level in a tank.
8. Check operation of the brake system. The pedal of a brake has to be rigid. If it is necessary, repeat pumping operation.




9710b8b3