Mazda 626

1991-1998 of release

Repair and operation of the car



Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and half shafts
- 9. Brake system
   9.1. Introduction
   9.2. Technical characteristics
   9.3. System of anti-blocking of brakes (ABS)
   9.4. Brake overlays of disk brakes
   9.5. Brake support
   9.6. Brake disk
   9.7. Brake shoes of drum brakes
   9.8. Wheel cylinder
   9.9. Main brake cylinder
   9.10. Brake tubes and hoses
   9.11. Pumping of the brake system
   9.12. Vacuum amplifier
   9.13. Height and free wheeling of a pedal of a brake
   9.14. Emergency brake
   9.15. Ropes of the emergency brake
   9.16. Switch of an alarm bulb of low level of brake fluid
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electrical circuitries
+ 14. Useful tips


9.10. Brake tubes and hoses

GENERAL INFORMATION

Approximately each six months examine rubber brake hoses on existence of cracks, traces of leak or wear. Replace hoses if it is necessary. Check a condition of brake tubes.

Survey and replacement

PERFORMANCE ORDER
1. Turn off a connection nut (at the left), remove a fixing clip and disconnect a hose or a tube (on the right).
2. Always replace copper sealing washers of connections of a banjo.
3. Use brake tubes of the required diameter and size. Do not use copper brake tubes. At installation check reliability of fastening of tubes and hoses.
4. After installation pump over the brake system.



9710b8b3