Mazda 626

1991-1998 of release

Repair and operation of the car



Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
- 8. Coupling and half shafts
   8.1. Introduction
   8.2. Technical characteristics
   - 8.3. Coupling
      8.3.1. Coupling switching off drive cylinders
      8.3.2. Hydraulic system of the drive of switching off of coupling
      8.3.3. Coupling mechanism elements
      8.3.4. Release bearing and fork of the release bearing
      8.3.5. Adjustment of a pedal of coupling
      8.3.6. Blocking switch
   + 8.4. Half shafts
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electrical circuitries
+ 14. Useful tips


8.3.3. Coupling mechanism elements

GENERAL INFORMATION

Wear of a press disk

1. Normal wear of plates of a spring
2. Excessive wear
3. Excessive wear of plates of a spring
4. The broken or bent plates

Clutch plate

1. Frictional material

2. Springs

3. Nave

4. Rivets

Removal

PERFORMANCE ORDER
1. Remove the transmission.
2. Mark the provision of installation of a press disk on a flywheel.
3. Gradually in a diagonal order turn off fixing bolts (shooters) and remove press a disk and a clutch plate.

Survey

PERFORMANCE ORDER
1. Examine a flywheel on existence of cracks, traces of an overheat, flutes or other damages.
2. Examine a clutch plate surface on existence of cracks, deformation and other damages. Check a condition of rivets and springs.
3. Check a condition of a diaphragm spring and a press disk for existence of scratches, cracks and traces of an overheat.
4. Examine the bearing on the end of a bent shaft on existence of wear, scratches or other damages.
5. Remove the bearing.

Installation

PERFORMANCE ORDER
1. Install the new directing bearing by means of a mandrel.
2. Establish a clutch plate and press a disk on a flywheel, holding a clutch plate by means of the adjusting tool.
3. Slightly twirl fixing bolts of a press disk.
4. By means of the adjusting tool adjust the provision of a clutch plate and gradually in a diagonal order tighten fixing bolts of a press disk till the required inhaling moment.
5. Grease an internal flute of the release bearing and install it into place.
6. Install the transmission on the car.



9710b8b3