Mazda 626

1991-1998 of release

Repair and operation of the car



Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Petrol engines (1,6 and 1,8 liters)
   + 3.2. Petrol 4-cylinder engine (2 liters)
   + 3.3. Petrol V6 engine (2,5 liters)
   + 3.4. Partition of engines (1,6 and 1,8 liters)
   + 3.5. Partition of engines (2,0 and 2,5 liters of V6)
   - 3.6. Diesel engine 2,0 liters
      3.6.1. Technical characteristics
      3.6.2. Maintenance, repair
      3.6.3. Principle of operation of the diesel engine
      + 3.6.4. Gear belt, installation of phases of gas distribution
      3.6.5. System of preliminary warming up
      3.6.6. Check of the device of preliminary warming up
      3.6.7. Removal of air from fuel system
      3.6.8. Check and replacement of the electromagnetic valve of a cut-off of fuel
      3.6.9. Check and adjustment of turns of idling
      3.6.10. Removal and installation of nozzles
      3.6.11. Removal of the vacuum pump
      3.6.12. Diagnostics of malfunctions of a power supply system of the diesel engine
   + 3.7. Systems of electric equipment of the engine
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electrical circuitries
+ 14. Useful tips


3.6.7. Removal of air from fuel system

GENERAL INFORMATION

It is necessary to delete air from fuel system after its opening or if the fuel tank was completely devastated.


Prevention

You watch that diesel fuel did not get on hoses of cooling liquid. Otherwise bars should be wiped at once. The struck hoses are subject to replacement.


PERFORMANCE ORDER
1. Make sure that in the fuel tank there is a fuel.
2. Open the screw of production of air (1) on the fuel filter.
3. Pump up fuel from the fuel tank the manual pump. The pump is on the top part of the filter.
4. Pump up fuel until via the screw of production of air fuel without air bubbles does not go.
5. Under pressure of the manual pump close the screw of production of air.
6. Pump up the manual pump until then (about 15 times), resistance will not begin to be felt yet.
7. If the engine is not started as in a fuel-supply line the air stopper was formed, weaken cap nuts on nozzles of injection and include a starter to a fuel exit. Then again tighten cap nuts and start the engine.



9710b8b3