Mazda 626

1991-1998 of release

Repair and operation of the car



Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
- 3. Engines
   + 3.1. Petrol engines (1,6 and 1,8 liters)
   + 3.2. Petrol 4-cylinder engine (2 liters)
   - 3.3. Petrol V6 engine (2,5 liters)
      3.3.1. Introduction
      3.3.2. Technical characteristics
      3.3.3. Recommendations about repair
      3.3.4. Top dead point of the first piston
      3.3.5. Covers of heads of cylinders
      3.3.6. Springs, clamps and epiploons of valves
      3.3.7. Gas-distributing belt and asterisks
      3.3.8. Camshafts and pushers
      3.3.9. Inlet collector
      3.3.10. Final collectors
      3.3.11. Heads of cylinders
      3.3.12. Forward epiploon of a bent shaft
      3.3.13. Oil pallet
      3.3.14. Oil pump
      3.3.15. Flywheel or drive plate
      3.3.16. Back epiploon of a bent shaft
      3.3.17. Fastenings of the engine
   + 3.4. Partition of engines (1,6 and 1,8 liters)
   + 3.5. Partition of engines (2,0 and 2,5 liters of V6)
   + 3.6. Diesel engine 2,0 liters
   + 3.7. Systems of electric equipment of the engine
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Running gear
+ 11. Body
+ 12. Electric equipment
+ 13. Electrical circuitries
+ 14. Useful tips


3.3.17. Fastenings of the engine

Check

PERFORMANCE ORDER
1. Lift and fix a forward part of the car.
2. Examine rubber shock-absorbers of support on existence of wear and damages, if necessary replace them.
3. Check that bolts of support were strong tightened.
4. Check whether support are worn-out.

Replacement

PERFORMANCE ORDER
Right support
1. Unscrew the through bolt of a support (A), the top bolts fixing a support to the engine (B). Remove a support.
2. Installation is carried out upside-down removals.
Forward support
3. The forward support is located between the engine and a radiator. Unscrew a through bolt of a forward support (A) and a nut) In), remove a support.
4. Installation is carried out upside-down removals.
Back support
Prevention

Access to this support is strongly complicated, for access simplification you can remove an inlet collector.


6. Unscrew a through bolt, twist nuts and remove a support. Unscrew a through bolt of a support (A) and bolts of an arm of the transmission (B).
7. Installation is carried out upside-down removals.
Left support
Top support
8. The support is attached to a body and the top part of the transmission. Unscrew a through bolt (A), a bolt (V) and a nut (C), disconnect wires and twist a nut (D).
Lower support

9. The lower support connects the transmission to the cross-piece located under it. Twist two nuts (A) and two bolts (In).




9710b8b3