Mazda 626

1991-1998 of release

Repair and operation of the car



Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
+ 10. Running gear
- 11. Body
   11.1. Introduction
   11.2. Maintenance and repair of a body
   11.3. Vinyl finishing
   11.4. Repair of insignificant damages of a body
   11.5. Repair of considerable damages of a body
   11.6. Loops and locks
   11.7. Replacement of a windshield and the neostarted-up glasses
   11.8. Replacement of a front grille (Mazda 626 model)
   11.9. Cowl
   11:10. Bumpers - removal and installation
   11:11. Forward wing
   11:12. The plastic panel before a windshield
   11:13. Panel of finishing of a door
   11:14. Doors
   11:15. Door lock, drum of the lock and handle
   11:16. Door glass
   11:17. Window regulator mechanism
   11:18. Rear-view mirrors
   11:19. Trunk lid (Mazdas 626 and MX-6 models)
   11:20. Lock and drum of the lock of a trunk lid (Mazdas 626 and MX-6 model)
   11:21. Ropes of opening of a cover of the luggage carrier / gate of the fuel tank
   11:22. Back door (Ford Probe models)
   11:23. Lock of a back door and drum of the lock (Ford Probe model)
   11:24. Basic racks of a back door / trunk lid (Ford Probe model, MX-6)
   11:25. Central console
   11:26. Panels of finishing of the dashboard
   11:27. Casing of a steering column
   11:28. Dashboard
   11:29. Sitting
+ 12. Electric equipment
+ 13. Electrical circuitries
+ 14. Useful tips


11.9. Cowl

Removal and installation

PERFORMANCE ORDER
1. Open a cowl.
2. Disconnect the wires and hoses preventing removal of a cowl.
3. Mark the provision of installation of loops on a cowl.
4. Turn off fixing bolts and remove a cowl.
5. Installation is carried out upside-down removals.

Adjustment

PERFORMANCE ORDER
1. Weaken fixing bolts or nuts and move a cowl as it is necessary. Tighten fixing bolts.


2. For adjustment of position of the lock of a cowl, weaken fixing bolts of the lock and move the lock as it is necessary.
3. Adjust height of rubber pillows of a cowl.
4. Periodically grease the lock and loops with lubricant on a lithium basis.

The cowl lock – removal and installation

PERFORMANCE ORDER
1. Mark the provision of installation of the lock. Remove the finishing panel from above of the lock. Turn off fixing bolts and a nut and remove the lock.


2. Remove a fixing clip.
3. Disconnect the end of a rope.
4. Installation is carried out upside-down removals.

Rope of opening of the lock – removal and installation

PERFORMANCE ORDER
1. Disconnect a rope from the cowl lock.
2. Tie a piece of a wire or a thick thread to a rope and remove a rope from fastenings in a motive compartment.
3. Remove an insert of a wheel niche.
4. Turn off fixing nuts (are specified by an arrow) and remove the handle of opening of a cowl and a rope from the dashboard.
5. Stretch a rope in salon and remove it from the car.
6. Installation is carried out upside-down removals.



9710b8b3