Mazda 626

1991-1998 of release

Repair and operation of the car



Mazda 626

+ 1. Maintenance instruction
+ 2. Maintenance
+ 3. Engines
+ 4. Heating and ventilation
+ 5. Fuel system
+ 6. Exhaust system
+ 7. Transmissions
+ 8. Coupling and half shafts
+ 9. Brake system
- 10. Running gear
   10.1. Introduction
   10.2. Technical characteristics
   - 10.3. Suspension brackets
      + 10.3.1. Rack of a forward suspension bracket
      - 10.3.2. Rack of a back suspension bracket
         10.3.2.1. Arm of a nave of a back wheel
         10.3.2.2. Nave and hug bearing of a back wheel
         10.3.2.3. Stabilizer of cross stability of a back suspension bracket
         10.3.2.4. Lever of a back suspension bracket
      10.3.3. Size of tires
      10.3.4. Angles of installation of wheels
   + 10.4. Steering
+ 11. Body
+ 12. Electric equipment
+ 13. Electrical circuitries
+ 14. Useful tips


10.3.2.4. Lever of a back suspension bracket

Removal and installation

PERFORMANCE ORDER
1. Remove back wheels.
Cross levers
Forward lever
2. Turn off and remove the through bolt (is specified by shooters) fixing levers to a nave arm.
3. Remove caps from a cross-piece of a back suspension bracket.
4. Turn off nuts of fastening of the internal ends of cross levers (are specified by shooters).
5. Mark the provision of installation of a cross-piece on the car bottom.
6. Establish a jack under a cross-piece, turn off fixing bolts and lower a cross-piece. Remove internal hinged bolts and remove the suspension bracket lever.
7. Installation is carried out upside-down removals.
Back levers
8. Disconnect connecting draft of the stabilizer of cross stability from the back cross lever.
9. Turn off the through bolt fixing the external ends of cross levers to a nave arm.
10. Mark the provision of installation of adjusting cams. Turn off internal fixing nuts and remove the back cross lever of a suspension bracket.
11. Installation is carried out upside-down removals.
Longitudinal levers
12. Remove a rope of the emergency brake from the suspension bracket lever.
13. Turn off a bolt of fastening of the lever to a nave arm.
14. Turn off a hinged bolt and remove the longitudinal lever of a suspension bracket.
15. Installation is carried out upside-down removals.



9710b8b3